How to install and use aluminum double head cutting saw machine

Aluminum double head cutting saw is the most important machine for making aluminum doors and Windows.It is mainly used for cutting aluminum door and window frame and material. Both left saw blade and right saw blade of this aluminum door window machine can be 90 ° and 45 ° cutting.The next is detailed introduction on how to install and debug the double head cutting saw machine for aluminum door and window.

(1) Installation:

After receiving aluminum double-head cutting saw,open the packing, inspection.And move the machine to installation location.

1.The machine should be installed on a hard flat concrete ground in the plant. Adjust the machine base to make sure it is level.

Tighten the lock nut on the adjusting screw.

2. Power supply: three phase and four wire, 380 v, 50 hz.

3.Grounding line according to the requirement of the electrical wiring diagram, the specifications should be chosen cross-sectional area is greater than 2 mm squared such soft copper core, grounding resistance is not greater than 4 ohms.

4.Working air pressure: 0.6 ~ 0.8 Mpa. Take the trachea in oil-water separator, check whether there is any air leakage phenomenon on pneumatic system.

(2) Adjustment:

After installing double head aluninum cutting saw machine, put through power supply and press the action button, check whether the circuit is normal. Determine the accurate before the machine for debugging.

1.The saw blade feeding speed regulation

The saw blade is driven by cylinder, feeding speed can be adjusted speed regulating valve.

2.The adjustment of the cutting angle

There are three kinds of Angle 90 °, 45 ° and 22.5 ° can adjust in use of the aluminum door window machine, after debugging in double saw before delivery inspection. After installation,you can choose the required Angle position directly, cutting aluminum profiles and check the profile error of the cutting Angle.If the double head cutting saw does not conform to the request, adjustable limit block on the height of screw, repeated cutting measure, to make it meet the requirements, then lock screw the nut on the can.

3.Adjustment of aluninum double head cutting saw machine scaleplate

The length of aluninum double head cutting saw machine is sure by manual adjustment. For example,if you want to cut one meter of aluminum profiles, only need to push the right head to the position of the 1 m.After cutting, you can use your own metric scale test, to see if the size is consistent.If not consistent, adjust the machine gauge pointer to the actual size.Before aluninum double head cutting saw machine leaving the factory, we have adjusted the scale of the machine accord to our own metric scale.

At last,welcome to our company for aluminum door window machine includes aluminum double head cutting saw machine, corner combing machine,end milling machine and so on.